
LED Guys is a licensed C10 electrical contractor and Tesla Energy Certified Installer serving Playa Del Rey, CA — from the beach cottages along Vista del Mar and the bluff-top homes above Del Rey Lagoon to the condo buildings and duplexes lining Culver Boulevard and Pershing Drive. We install Level 2 EV chargers, Tesla Wall Connectors, and the panel capacity that supports them, using outdoor-rated equipment specified for a salt-air coastal environment. Every installation is permitted through LADBS, coordinated with LADWP where service changes are required, and completed personally by the owner — no subcontractors, no call center, written quotes and transparent pricing from start to finish.
Playa Del Rey is a compact coastal neighborhood with an unusually wide mix of housing stock — 1920s and 1940s beach cottages on the small lots near Del Rey Lagoon, mid-century duplexes and fourplexes along Culver Boulevard, hillside homes on the bluffs off Napoleon Street and Waterview Street, and newer condominium buildings closer to the Marina. Each of these presents a different EV charging problem. A detached garage on a narrow beach lot needs a trenched or surface-run circuit; a bluff-top home may need a long conduit run from a side-yard panel; a condo owner needs a dedicated metered circuit routed from a shared electrical room. LED Guys handles all three.
The defining local factor here is salt air. Properties within a few blocks of the sand see accelerated corrosion on outdoor meter mains, service conduit, and equipment enclosures — and an EV charger mounted on an exterior wall is directly exposed. We specify outdoor-rated NEMA 4X enclosures, stainless or coated hardware, and properly sealed conduit penetrations on every coastal installation, and we inspect the existing service equipment for corrosion before adding load to it. Cutting corners on enclosure rating in Playa Del Rey produces a failure within a few years; doing it correctly produces an installation that lasts the life of the vehicle.
We reach Playa Del Rey from our Van Nuys base via I-405 S, serving the full 90293 ZIP code — the beach blocks west of Vista del Mar, the Culver Boulevard and Jefferson Boulevard corridors, the bluffs above Del Rey Lagoon, and the streets bordering Playa Vista and Westchester. All work is permitted through LADBS, and where a service upgrade or new meter is involved we coordinate directly with LADWP. Our clients choose us for honest pricing, meticulous workmanship, and a no-surprise process backed by a 5.0-star Google rating.
A simple, transparent four-step process for every installation in Playa Del Rey.
We visit your Playa Del Rey property, perform a load calculation on the existing panel, measure the conduit run to your parking location, and provide a clear written estimate at no charge.
Where required, we file all permits with the Los Angeles Department of Building and Safety, ensuring your project is fully code-compliant before work begins.
Jorge performs the installation personally — dedicated circuit, outdoor-rated enclosure where exposed, and a clean conduit run. No subcontractors on your Playa Del Rey property.
We coordinate the LADBS inspection, walk you through the completed work, and ensure everything passes before we consider the job done.
Playa Del Rey is a neighborhood within the City of Los Angeles, so all electrical permits are issued and inspected by the Los Angeles Department of Building and Safety (LADBS) — not by a separate city building department. Every Level 2 EV charger installation requires a permit and a final inspection under NEC Article 625, which governs electric vehicle power transfer systems, along with the load calculation requirements of NEC Article 220.
Where a service upgrade, new meter, or panel relocation is part of the scope, we also coordinate directly with LADWP, the electric utility serving Playa Del Rey. LED Guys files the permit, schedules the inspection, and is present on site for the inspector — the paperwork is not handed back to you.
Use our free home electrical load calculator to get a preliminary NEC Article 220 estimate of your available capacity before you call.
This calculator provides an estimate only. A licensed on-site evaluation is required before any installation.
All 12 services available throughout Playa Del Rey — ZIP code 90293.
Many Playa Del Rey beach cottages and duplexes still run on 60- or 100-amp service. We upgrade to 200-amp or higher to safely support EV charging, heat pumps, and modern appliance loads, with full LADBS permits and LADWP coordination where a new meter is required.
Electrical ServicesWe install Level 2 EV chargers and Tesla Wall Connectors throughout Playa Del Rey — attached and detached garages, alley parking, driveways, and condo parking structures. Outdoor-rated enclosures on every exposed coastal installation, permitted through LADBS.
EV Charger InfoFrom recessed can lighting in bluff-top homes above Del Rey Lagoon to under-cabinet LED strips in Playa Del Rey kitchens, we design and install LED lighting systems that reduce energy bills and elevate the look of any interior space.
Interior LightingOffices, retail suites, and mixed-use buildings along Culver Boulevard and Jefferson Boulevard can cut lighting costs dramatically with a commercial LED retrofit. We handle full fixture replacement, driver upgrades, and lighting layout redesigns.
Commercial LightingOlder Playa Del Rey properties with aluminum wiring or deteriorated knob-and-tube systems present real fire risks. Our full home rewiring service replaces outdated wiring throughout the entire structure, improving safety and bringing your home up to current code.
Electrical ServicesADU conversions are booming throughout Playa Del Rey as homeowners maximize property value. We provide dedicated subpanel installation, outlet and lighting rough-in, and LADBS-compliant electrical for new ADUs and garage conversions across all three ZIP codes.
Electrical ServicesPlaya Del Rey's high-value homes deserve intelligent lighting control. We install Lutron Caseta and RA2 systems, Leviton smart switches, and full smart home lighting integration — compatible with Alexa, Google Home, and Apple HomeKit.
Interior LightingFrom bluff-top properties overlooking the water to beach-lot homes near Vista del Mar, we design low-voltage landscape lighting systems built with corrosion-resistant fixtures suited to coastal exposure, improving security and highlighting architecture throughout Playa Del Rey.
Interior LightingPlaya Del Rey is home to content creators and audio professionals who need clean, isolated power. We wire dedicated circuits, isolated grounds, and studio-grade electrical systems built to handle high-end audio and recording equipment without interference.
Studio ElectricalBuilding new in Playa Del Rey? We handle complete electrical rough-in, panel sizing, conduit layout, and final trim for new construction projects — coordinating directly with your general contractor and LADBS from permit to final inspection.
Electrical ServicesSolar adoption continues to grow across Playa Del Rey. We wire solar inverters, connect battery backup systems like Tesla Powerwall, and install transfer switches — ensuring your system is properly integrated, permitted, and ready for utility interconnection.
Electrical ServicesElectrical emergencies don't wait for business hours. Whether you're dealing with a tripped main breaker, burning outlet smell, or sudden power loss at your Playa Del Rey home or business, call us now — we respond fast across 90293.
Call NowCoastal lots, older service panels, and shared parking create a predictable set of EV charging problems in Playa Del Rey. Here is what we see most often.
Many Playa Del Rey cottages and duplexes built between the 1920s and 1960s still run on 60- or 100-amp service — not enough headroom for a 40- or 48-amp continuous EV load. We run an NEC Article 220 load calculation first, then upgrade to 200-amp service where the numbers require it, permitted through LADBS.
Meter mains, disconnects, and exterior conduit within a few blocks of the sand corrode faster than inland equipment. Before adding an EV circuit we inspect the existing service for pitting and rust-through, and we mount new equipment in outdoor-rated NEMA 4X enclosures with sealed penetrations and corrosion-resistant hardware.
Small beach lots frequently put the garage at the rear of the property or off an alley, well away from the main panel. We handle long conduit runs, trenching where required, and subpanel installation at the garage so the charger gets full-rated current instead of a voltage-dropped circuit.
Condo buildings along Culver Boulevard and near the Marina often require a dedicated circuit run from a shared electrical room to an assigned space, with separate metering or submetering so the owner pays for their own charging. We prepare the documentation HOA boards ask for and complete the work to LADBS standards.
Homes on the bluffs off Napoleon Street and Waterview Street often have the service panel on the opposite side of the structure from the driveway. We size conductors to keep voltage drop within NEC limits over the full run so a 48-amp charger actually delivers 48 amps.
Adding a second EV charger frequently exceeds what the existing service can carry. Rather than defaulting to a costly service upgrade, we evaluate load management and power-sharing configurations that let two chargers share a single circuit safely — and recommend the upgrade only when the load calculation genuinely requires it.
A selection of recent projects completed by the LED Guys team.
Real feedback from real clients across the greater Los Angeles area.
"I recently hired Jorge to install LED strip lights for my custom cabinets, and I couldn't be happier. Professional, punctual, and incredibly skilled. The wiring was neatly hidden and the setup works seamlessly. Highly recommend for anyone looking for top-notch electrical work."
"Very knowledgeable and punctual. Easy to work with and reasonably priced. I will definitely use them in the future for all my lighting and electrical needs."
"Jorge is the man for any electrical work. He completed lighting installations for my shop and did an excellent job. Professional, efficient, highly satisfied. I highly recommend Jorge for any electrical issues or projects."
"You can't ask for a better electrician than George. He's reliable, communicative, on time, reasonably priced and a pleasure to work with. I've called George for multiple projects, including panel upgrades, recess lighting and even technical issues and he has performed like a champion every time."
"I've worked with many electricians over the years, and he's by far the best. His prices are great, he's always on time, reliable, and gets the job done without any issues. If you need an electrician you can truly count on, reach out to him — you won't be disappointed."
"LED Guys were awesome! They replaced and repaired my open sub panel quickly and made the whole process super easy. Friendly, professional, and explained everything in a way that made sense. Great to have peace of mind knowing the job was done right."
LED Guys serves all of Playa Del Rey — ZIP code 90293 — along with Marina del Rey, Westchester, Playa Vista, Venice, Mar Vista, Culver City, and El Segundo. From the beach blocks along Vista del Mar to the bluffs above Del Rey Lagoon.
Common questions from Playa Del Rey homeowners and property owners about EV charger installation.
LED Guys serves communities throughout the Westside, the San Fernando Valley, and greater Los Angeles.
Call or email LED Guys today for a free on-site estimate and load calculation. We serve all of Playa Del Rey — ZIP code 90293 — with licensed, LADBS-permitted Level 2 EV charger and Tesla Wall Connector installation.
The Tesla Energy Certified Installer designation identifies professionals who have completed Tesla Energy training, hold deep technical knowledge of Tesla Energy products, and deliver the highest-quality installations for Tesla customers. LED Guys holds this certification for both product lines — a combination very few Los Angeles electricians can offer.
LED Guys is certified by Tesla Energy to install the Tesla Wall Connector and Universal Wall Connector to Tesla's own installation standards. That certification covers the full scope of a residential or commercial Wall Connector project: conductor sizing per NEC Article 625, dedicated circuit breaker selection, conduit and wire routing, GFCI breaker protection per NEC 625.54, and proper grounding and bonding at the panel.
After the physical installation, Jorge commissions the Wall Connector through the Tesla One app — connecting the unit to Wi-Fi, registering it to your Tesla account, setting the output amperage to match your circuit, and configuring access controls if you want to restrict charging to authorized vehicles. For multi-vehicle homes and commercial sites, we configure Power Sharing so up to six Wall Connectors intelligently share a single circuit without exceeding its capacity.
The Wall Connector delivers up to 48 amps on a 60-amp circuit, the fastest Level 2 charging Tesla offers for home use. Its built-in amperage adjustment (12, 16, 24, 32, 40, or 48 amps) means it works with any panel — from a 100-amp service with limited headroom to a 400-amp commercial main. Tesla's NACS connector is now the North American charging standard (SAE J3400), so the Wall Connector charges Teslas natively and other EV brands via adapter or native NACS port. The Universal Wall Connector adds a built-in J1772 connector for households with mixed EV brands.
Certified for Tesla Powerwall home battery installations — whole-home backup, Backup Gateway integration, solar coordination, and Charge on Solar setup so your Tesla charges from excess solar production automatically.
Powerwall installations include gateway wiring, backup circuit selection based on your household's critical loads, and utility interconnection paperwork for LADWP net metering. Jorge configures Storm Watch, self-consumption mode, and time-based control through the Tesla app so your system responds automatically to grid conditions and rate schedules.
LED Guys is a GlowbackLED Trusted Lighting Installer — a designation earned by electrical contractors who consistently deliver high-quality installations of GlowbackLED's custom LED lighting systems. GlowbackLED is a US-based designer and manufacturer of architectural LED solutions: custom LED panels, recessed and pendant linear fixtures, LED aluminum channels, and cabinet lighting built to specification for high-end residential and commercial projects.
When a project calls for custom-fabricated LED lighting — a coffered ceiling with built-in linear channels, back-lit niches, under-cabinet strip lighting with dimmer controls, or a commercial lobby with signature pendant fixtures — Jorge sources components from GlowbackLED and installs them to their technical specifications. Every GlowbackLED installation includes proper driver placement, dimmer compatibility verification, and clean concealed wiring so the finished result matches the design intent.